Battery Type Used: Single-Point Watering System

The Type 6A200MR is a replacement for the EEP-2 probe that was designed for use on industrial batteries with single-point watering systems.

With these systems the battery cell cap is not available for the probe, so a small 1/8" diameter hole is drilled in the battery cover over the center

cell, the probe inserted and held to the cover by a stainless screw. A small neoprene O ring around the probe shaft seals the opening, preventing electrolyte leakage.

This probe is a big improvement over the EEP-2 and other probes that require large holes to be drilled to accommodate the grommets that are used for sealing.

The probe has a single bright green LED to show battery condition and acceptable acid level. A black wire with stainless screw is provided to connect to the outboard inter-cell strap of the adjacent cell in the direction of the battery negative post , and a red one for connecting to the outboard strap of the cell on the opposite side.

The length of the probe shaft is nominally 2", but other lengths can be provided.